Fixtures must be bolted down firmly to your Pallet or Table using the screws provided.
Do not alter or replace any screw, spring or clamp with anything other than the exact item provided.
Clamps must be tightened between 20 and 60 foot pounds of torque. DO NOT EXCEED 60 foot pounds. While for most applications tightening can be accomplished simply by using the T-Handle wrench provided, it is always recommended that a torque wrench be used until you establish the proper torque pressure for your application. Depending on the size of your workpiece and the material being cut you may need to adjust your clamping pressure. It is never recommended to under or over torque the clamps as this will lead to clamp or fixture failure.
When machining your workpiece with the dovetail it is critical that you follow our sketches. Failure to do so may result in the workpiece coming loose and or damage to your fixture. Pay close attention to required sizes and radius requirements on the sketches.
Failure to follow these instructions may result in injury or damage to your workpiece, tools, fixtures and/or machine.
RWP-1051 standard parallel (1/8 ledge) for the RWP-502 vise! •provides precise straight edge for clamping machines workpiece •good for light/medium duty machining •rail provides maximum support while allowing clearance on bottom of workpiece •hardened and ground steel •sold individually 0 Comments 19 Likes
RWP-1050 Serrated 45 degree dovetail which fits the RWP-502! •use as a dovetail clamp or serrated edge clamp •utilizes dovetail form for secure clamping and retention •bite height =.110 •dovetail width can be modified to fit different workpiece sizes •it ... 0 Comments 47 Likes
RWP-502 100mm Self centering vise! *all steel construction *automatically positions workpiece in center of vise *centering tolerance is +/-0.013 (0.0005) *repeatability is 0.001 *jaw clamping range is 0-2.500 as shown and 2.500-5.620 with jaws reversed! *jaw insert options available for ... 0 Comments 101 Likes
Piranha cooling line solves all cooling problems on chip-removing processing! *withstands pressure up to 80 bar *long lifespan thanks to anodized coating *fits on all standard tool holders * available in 1/8, 1/4 and 1/2 inch *Call us for more ... 0 Comments 34 Likes
The first picture shows a RWP-203 adapter with a RWP-002SS mounted to it with raw material on top. The second picture then shows what used to be raw material in its final phase with all 5 sides machined! 0 Comments 178 Likes
On Tuesday TE-CO hosted its annual chili cook off! There were 7 different pots in the competition! Employees tested each pot and voted on the one they liked best! Cynthia Hoover pot 5 was our winner! Congratulations Cynthia! 0 Comments 40 Likes
Piranha has two new 75mm vises to offer! *the one on left is a zero point mounting system *the one on the right is a direct mount Give us a call today for pricing and more information! 1 Comments 90 Likes
Thanks to Visoneering for the opportunity to see Raptor in action! The RWP-001 fixture on multiple applications and running 20 hours a day! The wall of Hurco! We love working with the aerospace projects and seeing the outcome! 0 Comments 112 Likes