RWP-019-4X90T

Utilizes (1) RWP-215 Body plus (4) RWP-019SS The RWP-019-4X90T is made from a 7075 Aluminum Base an the four RWP-019SS fixtures are made from 17-4 Stainless Steel.

The fixture clamps are made from 17-4 Stainless Steel.

This Raptor Nest tombstone mounts to the top of any of the following 1.5" dovetail fixtures: RWP-001, RWP-001SS, RWP-004, RWP-013, RWP-013SS, RWP-026.

* Typical workpiece size dimensions (L x W x H): From: 1.25" x 0.990" x 0.50" To: 2.50" x 2.50" x 2.50"

Patented Design. Patent US8,672,310 B2

Download 0.375" Dovetail Prep Drawing (pdf)
Dovetail Prep Troubleshooting (pdf)
Proper Dovetail Geometry (pdf)

• Fixtures must be bolted down firmly to your Pallet or Table using the screws provided.
• Do not alter or replace any screw, spring or clamp with anything other than the exact item provided.
• Tighten clamps only to published torque limits. Do not exceed torque limits. While for most applications tightening can be accomplished simply by using the T-Handle wrench provided, it is always recommended that a torque wrench be used until you establish the proper torque pressure for your application. Depending on the size of your workpiece and the material being cut you may need to adjust your clamping pressure. It is never recommended to under or over torque the clamps as this will lead to clamp or fixture failure.
• When machining your workpiece with the dovetail it is critical that you follow our sketches. Failure to do so may result in the workpiece coming loose and or damage to your fixture. Pay close attention to required sizes and radius requirements on the sketches.
• Failure to follow these instructions may result in injury or damage to your workpiece, tools, fixtures and/or machine.

Download Key Dimensions for RWP-019-4X90T (pdf)



Download Key Dimensions for RWP-019 (pdf)

Qty of four Raptor RWP-019SS dovetail fixtures
Qty of one Raptor RWP-215 tombstone